Multipanel
 |
INTRODUCTION 195 Euro 235 Euro inc. VAT PER SHEET Type: TILING ALTERNATIVE multiPANEL is the simple, Easy Fit economic alternative to tiling, in 1.2 x 2.4 metre panels. These sheets are fitted Directly to your walls, thereby meaning NO NEED TO TILE !!! The 11mm panels then eliminate the need for expensive tiling, grouting – and specialist Tilers multiPANEL is a WBP plywood wall panel bonded with a choice of 30 beautiful laminate finishes. Aluminium corner and capping profiles, and tongue and groove joints permit rapid installation, with minimal labour charges. No grouting is required as the panels simply wipe clean, meaning multiPANEL is the perfect “Easy Clean” solution for domestic and commercial wet areas. multiPANEL allows you to create a shower cubicle almost anywhere; easily and quickly. Panels can be cut to fit shower bases, e.g. 800mm, 900mm, 1000mm, etc. This will permit rapid, joint-free installation of shower units and enclosures, as well as providing a superb decorative finish. 195 euro per 1.2 x 2.4 metre SHEET, which is 11mm thick Tongue and Grooving is available for additional 10 euro per Edge Edge Finishing or Joint Strips & End Caps are also available in Lengths of 2.5 metres for: Euro 45 PER JOINT IN: Black, White, Chrome, Satin, Silver & Gold All prices quoted are Plus Vat and Delivery. |
|
 |
AFTER CARE How do I clean the panels? All multiPANEL products should be cleaned with warm water and a non-abrasive mild detergent. Do not use scouring powders or similar products. What is the warranty on multiPANEL products? 10 year warranty from the date of purchase that these panels will neither crack nor delaminate and will remain watertight, if installed, sealed and maintained according to published recommendations. |
|
 |
FIXING & FITTING QUESTIONS Can the panels be applied directly onto tile walls? Yes, provided they are sound. Can the panels be applied to plasterboard walls? Yes, by adhesive or screws to sub frames. How do I finish around doors and windows? By using corner extrusions and cut widths of panel to reveals. Exposed edges can be covered with end caps or butted to facings. How do I fix the panels? Fix through the back flange of grooved edge with No. 4 screws to battens, brick or plastered walls (wall plugs). The panels can also be fixed with adhesive directly to smooth and clean walls. How do I finish the panels at the floor and ceiling? Panel edges that are exposed can be covered with end caps (with silicone sealant) or alternatively butted hard to the floor (with silicone sealant). How do I cut the panels? Panels can be cut with a fine tooth power or hand saw - decorative face down with a power saw, and face up with a hand saw. Please ensure that protective eye-wear is worn when cutting panels. Can I use panels above 2400mm high? Panels can be joined using 'H' section extrusions. Panels can be supplied with tongue and groove short edges at additional cost. CLICK HERE for details of measurements, photos and prices CLICK HERE for details on installing this product |
Site Index
Back to Homepage
